3D Printer

At the moment I’m using a Creality Ender 3 Pro which prints really well for a cheap printer. When I bought the printer the original bed springs were too short and the heated magnetic bed was a bit warped, I replaced the springs with longer ones and set up the bed as best as I could but basically I only print on a small part of the bed. I’m awaiting a glass bed to replace the magnetic one and I should be able to utilize the entire bed for printing.

I use Sunlu high quality PLA+ check out my discount section for discounts up to 18% off

Creality Ender 3 Pro

Average Rating

5 Star
0%
4 Star
0%
3 Star
0%
2 Star
0%
1 Star
0%

Go ahead comment, you know you want to.

%d bloggers like this: