Artillery Genius auto shut-off

Added a solid state relay to my Artillery Genius which is connected to the extruder fan wire which only turns on over 50 C. When the extruder cools to under 50 degrees the printer shuts down.

When the extruder is under 50 c. you need to flip a switch to supply power to the printer after the printer is up to temperature the solid state relay takes over giving power to the printer, if you would like the printer to shut down after the print you just turn off the power switch the relay will keep the system energized until the nozzle temperature drops below 50 C.

New relay on the lower right.
I added some more upgrades but i’ll get to those in another post.
All wired up, unfortunately all I had was yellow wire.

Go ahead comment, you know you want to.